At Metronor we believe we can contribute significantly to the cost reduction programs that strive to cut cost base. These can include on-time delivery of quality parts that “fit first time”, standardization, modularity and subcontracting of engineering and component/part manufacturing.
We provide dimensional management solutions that secure geometrical verification of components and assemblies as an integral part of the manufacturing process.
YOU'LL BE ABLE TO...
Our systems have proven its value for their ability to measure all kinds of geometrical elements, both large and small parts, hidden and difficult to reach features.
The list of complex geometries that need to be inspected and qualified is long. Our systems’ technology is in the forefront of industrial dimensional measurement systems and can be used for:
Through an easy process, it is possible to transfer a pre-defined inspection plan to the measurement system at the supplier’s location and have the operators perform the inspection plan by simply following the instructions given by the software.
Just have the engineering team define the key characteristics of the parts beforehand and create a fully digital inspection plan while during the design process.
Any errors and out-of-tolerance data can be immediately detected, and the measurement report is transferred seamlessly back to the engineering team who decides on actions related to the severity of the dimensional problem.
New measurement datasets can be sent back to the customer with the improvements/corrections made to the part. This verifies that the part now meets the acceptance criteria.
Through this simple process, the buy-off process can be complete completed and the part released and shipped to the customer. Customer and supplier are both in sync and the part is guaranteed to fit when arriving for final assembly.
Our unique software for pipe geometry generation allows the user to create pipe geometries in digital form that can be transferred directly to the bending machine.
You can perform the verification of pipe geometries as an integral part of the bending process and secure correct alignment of flanges, both position and hole pattern orientation. And then provide correction data to the bending machine.
This represents an immense cost saving since the fabrication of new pipe sections to replace old existing pipes can be carried out in minutes after the geometry has been “reverse engineered” on site.
Our systems’ excellent accuracy performance, combined with deep probing capabilities, allow us to address the most challenging measurement jobs – Those that, until now, have only been possible to perform by traditional fixed CMM technology.
Complex geometries like tapered areas inside of connectors, spools, pumps and valves etc. can be documented on the shop floor.